Set-Up; Trap Placement; Burying The Cord - Mosquito Magnet PIONEER Operación Manual

Trap Placement

1. Determine the direction of the prevailing wind.
Check local weather patterns if you are unsure.
2. Stand in the center of the area you are trying to protect
and look toward the prevailing wind.
3. Proper placement of the trap will be approximately 10m
in front of you, within 1.5 to 2m of ground cover (i.e. bushes,
flowerbeds, tree line, marshbed). Ensure that trap is not
directly against any blockades such as buildings, fences, etc.
4. It is recommended that the trap be placed in the shade.
5. Do not place trap directly above a water source
(sprinklers, hose, etc.).
6. Trap must be placed on level ground to avoid tipping
or uneven propane distribution.
7. For optimal trap placement in your yard, refer to the
instructional video at www.mosquitomagnet.com/videos to
build your own yard diagram for correct trap placement.
Burying the Power Cord
Make sure unit is unplugged and in proper position. Use the
Cord Burying Clips supplied. Place clips approximately 1m apart,
press into ground by hand making sure not to damage power
cord. For alternate placement, follow steps illustrated below.
1. Use straightedge shovel or garden spade and dig a
trench about 8-10cm deep from power source to trap.
2. Place cord into trench carefully stretching as you go to
remove any twists in cord.
3. Use cedar shingle or folded cardboard to place cord into
bottom of trench. Recover the trench with removed soil.
E10

Set-Up