Quick KTB4 Manual De Instalacion Y Uso página 15

INSTALLATION OF THE KTBS TEMPERATURE SENSOR
• Thoroughly clean the surface of the battery where the KTBS will be applied.
• Remove the protective adhesive film.
• Apply the KTBS to the battery surface by pressing for 30 seconds.
• The KTBS must not be applied in the following positions:
WARNING: application of the KTBS on the battery is not recommended if the battery surface temperature is
less than 10°C. Secure adhesion of the KTBS will be completely achieved 72 hours after application.
KTB4N - REV001A
INSTALLATION
GB
15