Permissible Accessories; Storage And Handling Of The Recommended Accessory Tools; Working Procedures - Parkside PWS 230 D4 Traducción Del Manual De Instrucciones Origina

Permissible accessories

Max.
diameter
Ø (mm)
Cutting disc 230
Roughing disc 230

Storage and handling of the recommended accessory tools

■ Grinding tools are to be treated with care and transported carefully.
■ Grinding tools should be stored in such a way that they are not exposed to mechanical damage or
environmental influences (e.g. moisture).

Working procedures

NOTE
► Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
Rough grinding:
Never use cutting discs
for rough grinding!
■ Move the angle grinder with moderate
pressure back and forth over the workpiece.
■ For soft material, move the rough grinding
disc at a shallow angle over the workpiece;
for hard material at a slightly steeper angle.
Abrasive cutting:
Never use rough grinding
discs for cutting!
■
Use only tested fibre-reinforced cutting or
grinding discs that are approved for a circum-
ferential speed of not less than 80 m/s.
│ GB │ MT
■ 52
Max.
Thread
thickness
size (mm)
(mm)
3 M14
6 M14
Circumfer-
Speed
ential speed
(rpm)
(m/s)
6500 80
6500 80
CAUTION!
► The grinder continues running after being
turned off. Do not try to brake it by applying
lateral counterpressure.
■ Secure the workpiece! Use clamps/a vice to
hold the workpiece firmly in place. This is much
safer than simply holding it in your hand.
■ Always switch off the appliance before
putting it away and wait for the appliance to
come to a complete standstill.
■
Release the ON/OFF switch immediately in
the event of a power failure or when the plug
is pulled out. Move it into the OFF position. This
prevents an uncontrolled restart.
■ Use the appliance only for dry cutting or
sanding.
■ The additional handle
the appliance for all work.
■ Materials containing asbestos may not be
processed. Asbestos is a known carcinogen.
Tip! This symbol indicates proper
behaviour.
Blade
Tool
guard
Two-hole mounting
spanner
Two-hole mounting
spanner
must be mounted on
PWS 230 D4
Yes
Yes