OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
The direction that the door opens can be reversed by
following the below instructions.
• Ensure the appliance is unplugged and empty.
• We recommend that two people handle the appliance
during the door reversal process.
• If the appliance will be placed on its back, protect your
fl ooring with a blanket or towel.
• You will require a cross-bladed screw driver (Phillips
head).
The appliance may be placed on its back to complete
the door reversal however, any time the unit is placed
on its back or side you must allow it to stand upright for
a minimum of 6 hours before plugging it in to allow the
coolant to settle. Not allowing the coolant to settle can
cause the appliance to malfunction.
1. Remove the plastic hole covers located on the top left side
of the refrigerator as shown in Fig. 1.
2. Remove the upper hinge cover and the upper hinge on
the right side of the refrigerator, as shown in Fig. 2.
3. Remove the door from the lower hinge pin by pulling it
gently upwards. Remove the lower hinge bracket on the
right side of the unit and remove the leveling foot on the
left side. Reverse their positions as shown in Fig. 3.
4. Install the lower hinge on the left side of the refrigerator.
Install the adjustable foot on the right side of the
refrigerator as shown in Fig. 4.
5. Move the door bushing to the left and the plastic hole
cover to the right as shown in Fig. 5.
6. If there is a door stopper, move it from the right side of
the appliance to the left as shown in Fig. 6. If there are
two door stoppers, there is no need to move them. Install
the door onto the lower hinge pin, now located on the left
side of the appliance.
7. Install the upper hinge and hinge cover on the left side of
the unit. Place the plastic hole covers in the holes on the
right side of the top of the refrigerator to cover the screw
holes as shown in Fig. 7.
Note: When installing the door, ensure that the top of the
door is level with the top of the cabinet. If the door is not
level, the rubber gasket will not make a good seal with the
cabinet which can cause the appliance to malfunction.
IMPORTANT
11
1
2
3
4
5
6
7