Programming Instructions - Alcad MVC-140 Manual Del Usaurio

PROGRAMMING INSTRUCTIONS

The programming of the monitor must be done from the main entrance panel of the
system (See the corresponding installation manual).
The button / programming code is stored in the monitor. If the monitor is replaced, do
not forget to program it.
For installations with several devices (telephones or monitors) in the same home,
program all the devices one by one and with the same button / code.
Programming steps
1. Move the PROG switch to the OFF position; Return the switch to the
ON position.
2. Press the door open button
the monitor and the main entrance panel.
3. Located on the main street panel, make the call to the apartment
where the monitor to be programmed is located. The entrance panel
will emit a confirmation beep, the monitor has been programmed.
1
1
2
Note: Once the monitor is programmed, make sure that the PROG switch is in the
ON position.
Note: Maximum time of 1 minute between steps 1,2 and 3. After the maximum time
you must start programming from step 1.
VIDEODOOR ENTRY SYSTEM MONITOR
2
OFF
ON
. The audio will be activated between
3
ENG - 15