Midea MDT24H3AST Manual De Usuario página 37

PROBLEM POSSIBLE CAUSE
Dishwasher The water supplied to
seems to run
the dishwasher is not hot
too long
enough.
The dishwasher runs
longer while heating water,
and a delay automatically
occurs in some wash
and rinse cycles until the
water reaches the proper
temperature.
The Sanitize option is
selected.
The cycle time will vary
depending on soil level.
Dishwasher is connected
to the Cold water supply.
Water
The cycle is not complete
remains in the or it is in a pause.
dishwasher
The drain hose is kinked.
NOTE: A small
The knockout plug is still
amount of
in the garbage disposal.
clean water
around the
Drain hose is connected to
outlet in the
the garbage disposal, and
bottom of
the garbage disposal is
the tub is
not empty.
normal. It
keeps the seal
Drain is clogged.
lubricated.
Detergent The cycle has not
remains in the
completed.
dispenser
The detergent is damp or
has clumped.
An item was blocking the
dispenser.
The spray arm is blocked.
SOLUTION
Run the water in the
adjacent sink until it gets
hot before turning on the
dishwasher.
The cycle time increases
to heat the water to the
correct temperature for
sanitizing.
When heavy soil is
detected, the Normal cycle
will automatically increase
the cycle time.
Verify the dishwasher is
connected correctly to the
Hot water supply.
The water will drain when
the cycle is completed.
Straighten the drain hose.
Remove the knockout plug.
Run the garbage disposal
until it is empty.
Check the air gap.
Close the door and press
START to complete cycle.
Remove detergent and
replace with fresh dry
dishwasher detergent.
Remove item. Remove
detergent and replace
with fresh dry dishwasher
detergent.
Load the dishes in a
manner that does not
block the spray arm from
rotating freely.
37