To Add, Reprogram Or Change; Keyless Entry Pin - Craftsman 139.53985DM Manual Del Propietário

NOTE:
USING
To Add, Reprogram or Change a Keyless Entry PIN
Your new Keyless Entry must be programmed to operate your garage door opener.
THE "LEARN" BUTTON USING THE PREMIUM CONTROL CONSOLE
1. Press and release the "learn"
button on motor unit. The learn
indicator light will glow steadily for
30 seconds•
2. Within 30 seconds, enter a four
digit personal identification number
(PIN) of your choice on the keypad•
Then press and hold the ENTER
button•
3. Release the button when the motor
unit lights blink• It has learned the
code. If light bulbs are not installed,
two clicks will be heard•
To change an existing, known PIN
If the existing PIN is known, it may be changed by one
person without using a ladder•
1. Press the four buttons for the present PIN, then press and
hold the # button•
The opener light will blink twice• Release the # button•
2. Press the new 4-digit PIN you have chosen, then
press Enter•
The motor unit lights will blink once when the PIN has been
learned•
Test by pressing the new PIN, then press Enter• The door
should move.
To set a temporary PIN
You may authorize access by visitors or service people with
a temporary 4-digit PIN. After a programmed number of
hours or number of accesses, this temporary PIN expires
and will no longer open the door. It can be used to close the
door even after it has expired• To set a temporary PIN:
1. Press the four buttons for your personal entry PIN (not the
last temporary PIN), then press and hold the • button•
The opener light will blink three times• Release the button•
2. Press the temporary 4-digit PIN you have chosen, then
press Enter•
The opener light will blink four times•
NOTE: This method requires two people if the Keyless
Entry is already mounted outside the garage.
•Enter a four digit personal
identification number (PIN) of your
choice on the keypad• Then press
and hold ENTER•
2. While holding the ENTER button,
press and hold the LIGHT button on
the Premium Control Console.
.
Continue holding the ENTER and
LIGHT buttons while you press the
push bar on the Premium Control
Console (all three buttons are held).
4. Release buttons when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
...J /
36
3. To set the number of hours this temporary PIN will work,
press the number of hours (up to 255), then press the
button•
OR
3. To set the number of times this temporary PIN will work,
press the number of times (up to 255), then press the #
button•
The opener light will blink once when the temporary PIN
has been learned•
Test by pressing the four buttons for the temporary PIN,
then press Enter• The door should move. If the temporary
PIN was set to a certain number of openings, remember
that the test has used up one opening• To clear the
temporary password, repeat steps 1-3, setting the number
of hours or times to 0 in step 3.
One Button Close: Opener can be closed by pressing only
the ENTER button if the one button close feature has been
activated• This feature has been activated at the factory. To
activate or deactivate this feature press and hold buttons 1
and 9 for 10 seconds• The keypad will blink twice when the
one button close is active• The keypad will blink four times
when one button close is deactivated•