Fault Messages And Fault Elimination; Accessories; Disposal; Warranty - Apex Tool Group Weller WDH10T Manual Del Usaurio

8-8
Message/Symptom
Soldering iron does not switch
off after being deposited on
holder
Soldering iron no longer
switches on after removal from
holder

8 Fault messages and fault elimination

Possible cause
SETBACK time on the
soldering station is activated
The holder is not correctly
connected
Movable funnel or shift linkage
is jammed

9 Accessories

Dry cleaning insert WDC 2, T005 15 125 99
Spiral wool, T005 13 841 99

10 Disposal

Dispose of replaced device parts and old devices in accordance with
national regulations.

11 Warranty

Claims based on defects will fall under the statute of limitations
12 months after delivery to the purchaser of the goods. This shall not
apply to rights of recourse of the purchaser according to sections
478, 479 German Civil Code.
We shall only be liable in the case of a warranty we have issued if
the quality or service life guarantee has been issued by us in writing
with reference to the term "warranty".
Subject to technical alterations and amendments!
See the updated operating instructions at www.weller-tools.com.
WDH 10T/20T
Corrective measures
Soldering iron only switches off
after the set time:
 Set the SETBACK time on the
soldering station to 0.
 Check connecting cable
- Holder cable – soldering
station
- Soldering iron - holder
Check funnel and shift linkage