SEAT INSTALLATION - LAP/SHOULDER BELT ONLY
1
2
3
Place carrier on an approved vehicle seat
location.
1 Place the car seat rear-facing on the
vehicle seat. Route the lap portion of the
lap/shoulder belt through the lap belt
guides on both sides of carrier. Make sure
the belt lies flat and is not twisted. Fasten
the buckle.
2 Check the red line level on the side of the
shell to make sure it is level to the ground.
3 Route the shoulder portion of the belt
around the rear of the seat and under the
shoulder belt guide. If vehicle belt latch
plate does not lock, then retractor must
be switched.
33