Marq HAZE800DMX Guía De Usuario página 5

Usage
Important:
•
Wait for 2–3 minutes for Haze 800 DMX to warm up. During this time, do not press any buttons on
the remote control. The Ready light on the remote control will illuminate when it is ready to use.
•
The rear panel's control settings will override any remote control settings. If you are going to use
the remote control, use the rear panel controls to set the amount of haze and fan speed to 0 (off).
•
Depending on the amount of haze generated, this product may set off smoke detectors.
•
In certain environments after prolonged use, the haze produced may leave a slippery residue on
floors and other surfaces.
If you are using the remote control:
•
To activate/deactivate the timer, press Timer On/Off on the remote control. When activated,
the Timer light will illuminate and you can do the following:
To set the amount of haze, turn the Output knob on the remote control.
o
To set the amount of time of each release of haze, turn the Duration knob on the
o
remote control. The available range is approximately 1–30 seconds.
To set the amount of time between each release of haze, turn the Interval knob on the
o
remote control. The available range is approximately 1–30 minutes.
Note: It can take up to 30 seconds for the new values to take effect.
•
To activate a continuous output of haze, do one of the following:
Press Continuous to activate it. Press Continuous again to deactivate it.
o
Press and hold Manual to activate it. Release Manual to deactivate it.
o
If you are using the rear panel controls only (no remote control):
•
To set the amount of haze, press Function to cycle through the menu options until h and a
number appears: 0 (off), or 1 (low) through 5 (high). Use the Up/Down buttons to set a new value.
•
To set the fan speed, press Function to cycle through the menu options until F and a number
appears: 0 (off), or 1 (slow) through 5 (fast). Use the Up/Down buttons to set a new value.
•
To set the DMX address, press Function to cycle through the menu options until d and a
number appears: 001 through 512. Use the Up/Down buttons to set the address. See the
following DMX Control
When you are done using Haze 800 DMX, do not power it off immediately. Instead, set the amount of
haze to 0 (off, as described above), and then wait for 1–2 minutes. This will allow the heater to clear
itself of any remaining fluid.
section to learn more about using Haze 800 DMX with a DMX controller.
5