Remotec Z-URC 550 Instrucciones De Operación página 6

Resetting your network
You can reset your remote to clear all Z-Wave network and device information
by the following steps:
Note: After reset the remote, each device should individually perform in the
section on "Delete device from the network" and "Add device to the
network".
1. Enter Z-Wave Additional Feature Mode by pressing and holding the Conf
and Remove keys for 3 seconds then the OK light will remain on.
TM
2. Enter 8761 on the XpressZetup keypad the OK light will flash once after
you enter one digit and turns on after entering all 4 digits.
3. The OK light flashes once slowly and then turns off indicating the reset was
successful.
Note: If the reset is unsuccessful, the OK light turns off and the error light will
flash 6 times then turn off.
4 WIRELESS INFORMATION
Wireless range:
This device has an open air line of sight transmission distance of 100 feet
which complies with the Z-Wave standards. Performance can vary depending
on the amount of objects in between Z-Wave devices such as walls and
furniture. Every Z-Wave device set up in your house will act as a signal
repeater allowing devices to talk to each other and find alternate routes in the
case of a reception dead spot.
Radio frequency limitations:
1. Each wall or object (i.e.: refrigerator, bookshelf, large TV, etc) can reduce
the maximum range of 65 feet by up to 25 to 30%.
2. Plasterboard and wooden walls block less of the radio signal then concrete,
brick or tile walls which will have more of an effect on signal strength.
3. Wall mounted Z-Wave devices will also suffer a loss of range as they are
housed in metal junction boxes which could reduce the range by up to 25 to
30%.
10
GB
5 AUDIO VISUAL SETUP AND OPERATION
TM
Your Z-URC is a state-of-the-art device which will give you greater control
over your houses electrical products than ever before. This section will guide
you through the set up and operation of the audio visual products in your
house. After set up please store this manual for future reference.
KEY FUNCTION DESCRIPTIONS
1. Press once to access secondary functions for the next button.
SHIFT
Press and hold to activate shift lock for permanent use of
secondary functions. Press shift again to release shift lock.
The Z-URC
accessed by using the shift key and TV or DVD and so on.
Note: The shift key is used when operating both the AV
2. Turns device for remote's current mode on or off.
3. Selects TV mode.
4. Selects Auxiliary mode normally assigned to audio equipment.
SAT
5. Selects satellite or cable receiver and similar devices such as
CBL
DVB-T, IP TV and so on.
6. Selects DVD player or other optical disc players such as Blue
Ray and PVR.
7. Changes the volume level of the device.
8. Changes the channel up and down.
P
9. Scrolls through AV modes while in TV mode.
AV
10. Selects the Electronic Program Guide while in SAT/CBL mode
also INFO when in shift mode.
11. -/-- also LAST in shift mode to return to the previous channel.
12. Toggles between TV and radio also HELP when in shift mode.
13. Menu, also EXIT when in shift mode.
TM
550 operates up to 8 AV devices which are
equipment and Z-Wave equipment.
11
GB