Check Installation - Chicco KeyFit 30 Manual De Instrucciones

INSTALLATION USING LATCH
LATCH or Vehicle Belt? This Child Restraint can
be safely installed using Vehicle Belts or LATCH.
Use the method that results in the MOST
SECURE installation in your vehicle.
.Remove LATCH.Connectors.
1
from.storage.pockets.while.lifting.
up.on.LATCH.Release.Lever.
.Position Base.in.forward.facing.
2
vehicle.seat.with.Recline.Foot.
against.seat.back.
.Adjust Base Angle.by.pushing.
3
Recline.Buttons.while.lifting.Base...
Angle.is.correct.when.Bubble.is.
between.arrows..
.
Vehicle must be on a level surface for
the Bubble to indicate correctly.
.Attach LATCH Connectors.by.
4
pushing.them.firmly.onto.vehicle.
LATCH.Anchor.Bars...Verify.
connection.is.secure.by.pulling.
firmly.on.LATCH.straps.
This child restraint base is designed to be used with lower LATCH
anchors at the standard spacing (11 inches) ONLY! Refer to vehicle owner's
manual for information about LATCH and child restraint installation positions.
1
2
3
CLICK!
4
34
INSTALLATION USING LATCH
.Tighten LATCH Belts.by.
5
pulling.up.firmly.on.LATCH.Pull.
Strap.while.pressing.Base.firmly.
into.vehicle.seat.
.Store LATCH Pull Strap.neatly
6
in.Pull.Strap.Storage.Pocket..

.Check Installation

7
. .LATCH belts MUST.be.. .
a
. . TIGHT
. .Base.MUST.be.STABLE
b
. .Bubble.MUST.be
c
. . between.arrows
. .LATCH Pull Strap.MUST
d
. . NOT.interfere.with
. . attachment.of.Carrier
. . to.Base.
.Attach Carrier to Base.after.
8
properly.securing.child.in.Carrier...
ALWAYS lift up on Carrier
to verify it is properly attached
to the Base.
5
6
7
.
8
35