Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WPE 26N (Interface) OUTPUTS
Limiter
In this tab you can enable and adjust the different sections of the limiter tab by clicking on its respective
the window.
In the graph you can see the curve obtained after the application of each element.
Limiter
Is set with the top point of the graph,when enable it pass to gray color and can be moved and set its level.
The Threshold knob adjusts the trigger threshold as much as attack and release times.
Compressor
Compression is set to the next point, also changing to gray to allow movement. with the Compression knob you can
adjust the ratio.
Linear
Sets the linear region of the curve by adjusting the third point.
Noise Gate
A noise gate is set to the lowest point, the ratio can be adjusted with the attached knob.
Quick Guide
NOTE: Each output can be configured so individually,
anyway, if some of them are going to be identical or
want to save time on your configuration, use the icons
marked to copy and paste the complete setup of a way
out another.
- 10 -
WPE 26N
tab inside
www.work.es
Publicidad
Tabla de contenido
