Troubleshooting - Brady MiniMark Guía Del Usario

The parameters include:
Ports
Select the correct port to link with the printer. The port may be
one of parallel (LPT), serial (COM), USB001 or File.
Paper size
Select the proper size in the menu.
Orientation
Set portrait or landscape according to the print direction.

10. Troubleshooting

Normally, when the printer is in abnormal condition, the power LED will
keep blinking. The printing job and the communication between the host
and printer will stop.
To understand the problem, please check both LEDs first:
A. Power and Ready LEDs blink at the same tempo
Power LED Ready LED
ON ON
OFF OFF
Possible Problems Solutions
Miss-detect the gap . Check the label path
(Die-cut label) . Check the label sensor
Remarks
If you are using
continuous label roll
and run under
Windows, you should
select the continuous
media.
23
Possible Problems Solutions
Label out . Supply the label roll out
Label not installed . Install the label roll
Label jam . Recover the jam
B. Power and Ready LEDs blink alternately
Power LED Ready LED
ON OFF
OFF ON
Possible Problems Solutions
Ribbon out . Supply the ribbon roll
Ribbon jam . Recover the jam
Ribbon sensor error . Replace the ribbon sensor
C. Only the Power LED blinks
Power LED Ready LED
ON ON
OFF ON
Possible Problems Solutions
Serial error . Check the baud rate
Memory full . Add the extension
RAM
Cutter failed, or jam at . Check the cutter
cutter . Recover the jam
Hardware error . Call for service
24
Remarks
Remarks
Not applicable to
direct thermal
type.
Remarks
Not for Centronics
It occurs when cutter is
activated but connection
cable is disconnected