To Lubricate The Gear Housing; To Clean And Lubricate The Blades; To Examine The Blades; Troubleshooting - RedMax CHT220 Manual De Usuario

4. Push the unwanted oil out of the air filter while in the
plastic bag.

To lubricate the gear housing

• Use RedMax special grease. Speak to your servicing
dealer for more information about recommended
grease.
• Add the grease through the cap on the gear housing.
CAUTION:
Do not fill the gear housing
fully.

To clean and lubricate the blades

1. Clean the blades from unwanted materials before
and after you use the product.

Troubleshooting

The engine does not start
Problem
Starter pawls
Fuel tank
Carburetor
1133 - 006 - 30.01.2021
Troubleshooting
Possible cause
The starter pawls cannot
move freely.
Incorrect fuel type.
Incorrect idle speed.
2. Lubricate the blades before long periods of storage.
Note:
Speak to your servicing dealer for more
information about recommended cleaning agents and
lubricants.

To examine the blades

1. Remove the cap on the gear housing.
2. Make sure that the blades move freely. Put the
combination wrench in the gear housing and turn
clockwise and counterclockwise.
3. Examine the edges of the blades for damages and
deformation.
4. Use a file to remove burrs on the blades.
Recommended step
Adjust or replace the starter pawls.
Clean around the starter pawls.
Speak to an approved servicing dealer.
Drain it and use correct fuel.
Adjust the idle speed.
13