Assembly - Truper ASPI-08X Instructivo

Assembly

A
• Disconnect the power cord from the power source.
• Open the container to remove all the accessories as
indicated in page 5.
B
• Turn the container upside-down and insert the two
wheels (A) into the base and in the front orifices.
• Insert the wheels axis (B) in the base. Set a washer in the
axis and then the rear wheel. Set another washer after the
wheel is set. Insert the pin (C) in the orifice found at the
axis end to secure the wheel. Repeat the same steps in the
C
other side of the axis.
• Install the cartridge filter or foam filter depending on the
material to vacuum (see page 8).
CAUTION
Remember to use the vacuum cleaner
with one of those filters installed otherwise the motor will
get damaged and the warranty will be void.
• If vacuuming dusts, fix the tongue (D) in the collecting
D
pouch inside the vacuuming port. Use care not to damage
the pouch.
• Set the head back onto the container, aligning the upper
section with the latches. Hook the latches (E).
• Insert the lock side of the hose (F) into the vacuuming
F
port and turn until it stops.
• Select the desired accessories and push them into the
suction wand.
E
7
ENGLISH