Tripp-Lite AG-013D Serie Manual Del Propietário página 17

5. Using the Digital Display
Fault Code Menu
The Fault Code Menu is only available when a breaker is tripped, causing the Breaker Trip LED to
illuminate. The display will jump to the Fault Code menu and auto scroll through the tripped
breakers (only tripped breakers will be shown in the scroll sequence). Manual scrolling option is still
available, but Auto Scroll feature will remain active within the fault code menu while a fault exists.
If Auto Scroll is disabled, the display will still jump to the Fault Menu but you must manually scroll
through each tripped breaker individually. The number in the 3-digit display is defined as:
br1 = Output Breaker L1-L2; br2 = Output Breaker L2-L3; br3 = Output Breaker L3-L1
Breaker 1 Tripped
Breaker 2 Tripped
Breaker 3 Tripped
IP Address Display
At any time, you can press and hold both Mode and Enter buttons for 2 seconds to show the IP
address of the connected SNMP card. The 3 digit display will show "IP". The 2 digit display to the right
of it will show one IP address digit at a time until it shows the entire IP address. Decimal points and
colons will be shown as hyphens. Note: This display supports IPv4 AND IPv6 addresses. The display
will automatically transition back to whatever mode it came from after displaying the IP address.
16-01-031-933588.indb 17
F C
F C
F C
I P
I
Note: Total of six breakers br1-br6
17
3/22/2016 4:14:23 PM