Tripp-Lite AG-013D Serie Manual Del Propietário página 3

2. Installation
2.1 Mounting the Automatic Transfer Switch (ATS)
Mount your equipment in a 4-post rack or rack enclosure. The user must determine the fitness of
hardware and procedures before mounting. If hardware and procedures are not suitable for your
application, contact the manufacturer of your rack or rack enclosure. The procedures described in this
manual are for common rack and rack enclosure types and may not be appropriate for all applications.
Note: Each snap-in slide rail assembly consists of a sliding rack enclosure mounting bracket and an inner
channel rail. For ease of installation, the inner channel rails come pre-attached to the ATS unit.
1
Align the rear bracket's tabs with the rack
enclosure's square mounting holes
and push the metal hooks through the
mounting holes
toward the enclosure support post in
order for the blue tabs to snap into the
mount 1A . Align the front bracket's tabs
with the rack enclosure's front square
mounting holes and push the metal
hooks through the mounting holes.
Finally, push the front bracket toward the
enclosure support post in order for the
blue tabs to snap into the mount
2
Repeat step one for the second mounting
bracket on the opposite side of the rack
enclosure.
3
Once both mounting brackets are fixed
onto the rack enclosure, secure the rear
brackets using the included M5X10L
screws.
4
Align the inner channel rails attached to
the ATS with the mounting brackets. Then
slide the unit into the rail assembly. Using
a screwdriver, secure the ATS's panel-
mounted screws to the rack enclosure.
16-01-031-933588.indb 3
1A
1B . Push the rear bracket
.
1B
1A
1B
3
4
3
3/22/2016 4:14:16 PM