Installing Cables - peerless-AV FPE47F-S Instalación Y Ensamblaje

Removal of Rear Supports: Remove 3" serrated
1-2
washer head screws and locknuts at top and
bottom of rear supports as shown in detail 2 and
lift rear supports out.

Installing Cables

Cables may be routed through top, bottom, or rear of main enclosure assembly. An additional available option for
2
cable entry while maintaining the waterproof seal of the enclosure is the ROXTEC cable gland (F).
Install ROXTEC hardware to top, bottom, or rear of enclosure assembly (A). NOTE: If cables are routed through
rear enclosure assembly hole, wall mount is required for mounting to wall.
Follow the ROXTEC manufacturers' instructions for installation included in ROXTEC cable gland (F) box.
Install cord cover plate assembly (K) to remaining open holes of enclosure assembly (A) as shown in detail 3.
LOCKNUT
LOCKNUT
A
K
DETAIL 3
6 of 50
ISSUED: 07-12-10 SHEET #: 061-9056-8 03-05-13
3" SCREW
REAR SUPPORT
3" SCREW
DETAIL 2