peerless-AV SP850 Instalación Y Ensamblaje página 8

Slide one mesh sleeve (F) over each cable. Use
6
cable ties (G) to tighten both ends of mesh sleeves
to cables.
Note: Loop cable ties through cable mounts and
tighten cable and mesh sleeve to cable mounts.
G
Screen can tilt 5° or 10° forward.
8
Note: Screen must be securely attached to mounting plate with all fasteners before adjusting tilt.
To tilt screen 5° forward, lift and pull mounting plate forward until middle notch rests on M6 screw as shown in fi gure
8.1. Tighten M6 screw (both sides) and M10 screws (both sides).
To tilt screen 10° forward, lift and pull mounting plate forward until rear notch rests on M6 screw as shown in fi gure
8.2. Tighten M6 screw (both sides) and M10 screws (both sides).
Note: For security models, tighten M6 screw using security allen wrench (M). For all M10 screws, use 6 mm allen
wrench (not included).
fi g. 8.1
F
M6 SCREW
MOUNTING
PLATE
M10 SCREW
5° tilt
Optional: To lock mount in closed position, insert
7
one M5 x 40 mm screw (DD) into tapped hole in
either top or bottom of fl at plate.
Note: Screen not shown for clarity.
TAPPED HOLE
CABLE MOUNTS
fi g. 8.2
8 of 21
FLAT
PLATE
MOUNTING
PLATE
10° tilt
ISSUED: 10-12-05 SHEET #: 202-9038-9 06-29-11
DD
TAPPED HOLE
M6 SCREW
M10 SCREW