Kohler K–10280 Guia De Instalacion página 3

1. Install the Spout
Remove the temporary nipple from the bath elbow.
CAUTION: Risk of internal seal damage. Loosen spout setscrew
with a 5/32" hex wrench prior to installing the spout.
CAUTION: Risk of internal seal damage. Do not use
petroleum-based lubricants. If spout will not slide over tubing,
use soapy water or a silicone-based lubricant.
Slip-Fit Spout
Apply thread sealant and install a 1/2" copper tube to extend
between 2–1/8" (5.4cm) and 3–1/2" (8.9cm) beyond the finished
wall.
Deburr the copper tubing.
Loosen the setscrew with a 5/32" hex wrench.
Apply plumbers putty or other sealant, according to the putty
manufacturers instructions, around the base of the escutcheon,
leaving a small gap free of putty at the bottom of the escutcheon.
Install the spout and carefully retighten the setscrew. Do not
overtighten the setscrew.
Remove any excess putty.
Kohler Co. 3 1018256-2-A