JB Systems LEDCON-02 MK2 Manual De Instrucciones página 6

ENGLISH
FUNCTIONS (REAR)
9. POWER SWITCH: used to switch the unit ON/OFF
10. DC INPUT: connect the supplied AC/DC adapter to this input. If you should use another adapter, please
make sure that it has 9Vdc and minimum 300mA with + in the center.
11. DMX OUTPUT: Sends DMX-signals to the connected units.
12. CHASER CHANNEL MODE: used to determine if the LEDCON-02 MK2 should work as a 4 or 8 channel
LED light modulator. Please note that you should always run the "auto address" function after changing
the channel mode!
CONNECTIONS
With LED MANAGER and/or MINI LED MANAGER:
 Just "daisy chain" the DMX in/outputs of 1 or more LED-Managers with the DMX-output of the LEDCON-02
MK2 remote using a good quality balanced cable.
 The LEDCON-02 MK2 remote will be used to control all connected slaves. The LED Managers are
automatically switched as simple DMX controlled LED power supplies (DMX-LED is lit). The controls on
the LED Manager(s) are disabled since they become slaves that carry out the instructructions given by the
LEDCON-02 MK2.
With LED BALL, LED SPOT/WASH, or other LED projectors:
 Just "daisy chain" the DMX in/outputs of 1 or more LED BALL and/or LED SPOT/WASH projectors with the
DMX-output of the LEDCON-02 MK2 remote using a good quality balanced cable
JB SYSTEMS
®
4/39
OPERATION MANUAL
LEDCON-02 Mk2