Error Codes - Lanaform TS1 Manual De Instrucciones

The heart rate is higher
or lower than the average
measurement of the user.
The power supply
is automatically
disconnected.
Air is blown when
measuring.

ERROR CODES

Err 0.: No pulse detected due to poor positioning during measurement.
Err 1.: Significant leak from the sleeve or insufficient inflation.
Err 2.: Not possible to obtain systolic pressure.
Err 3.: The pressure of the sleeve is too high.
Err 4.: Not possible to obtain diastolic pressure or pressure outside of legal range.
Err 5.: Deflation occurs too quickly.
Err 6.: Deflation occurs too slowly.
Err 7.: Systolic pressure outside of legal range.
Err 8.: Average pressure outside of legal range.
Err 9.: The pressure of the sleeve is insufficient, even when pumping of
maximum values.
The arm or body moved
during the measurement.
Measurement preformed
immediately after
exercising.
System design
Normal operation; if the
user's blood pressure
exceeds the initial
pressure, the device
will inflate automatically
to a higher pressure in
increments of 20 mmHg
* until it reaches an ad
hoc pressure.
The sleeve is not attached Reattach the sleeve.
Do not move your
arm or body during
measurement.
Do not perform
measurements
immediately after
exercising.
Press the Start/
Stop button again
and perform a new
measurement.
Version 01 of 04/10/2010
EN
TS1
11