How To Remove Odors From Refrigerator; Energy Saving Ideas; How To Remove And Replace Light Bulbs - Kenmore 596.53462302 Guía Para El Uso Y Cuidado

Dúplex
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Hints and care,
How to remove odors
from refrigerator
1. Remove all food.
2. Disconnect refrigerator.
3. Clean the following items–paying
special attention to crevices–using
the appropriate instructions in How to
Clean Your Refrigerator:
• Walls, floor, and ceiling of cabinet
interior.
• Drawers, shelves, and gaskets.
4. Wash and dry all bottles, containers,
and jars. Discard spoiled or expired
items.
5. Wrap or store odor-causing foods in
tightly-sealed containers to prevent
reoccurring odors.
6. Connect power to refrigerator and
return food.
7. After 24 hours, check if odor has
been eliminated.
If odor is still present...
1. Remove drawers and place on top
shelf of refrigerator.
2. Pack refrigerator and freezer
sections–including doors–with
crumpled sheets of black and white
newspaper.
3. Place charcoal briquettes randomly
on crumpled newspaper in both
freezer and refrigerator
compartments.
4. Close doors and let stand 24–48 hours.
5. Repeat steps 5 through 7 above.
If odor was not eliminated, contact Sears
Service Center. Refer to back of manual
for phone number.

Energy saving ideas

➢ Avoid overcrowding refrigerator
shelves. This reduces effectivity of air
circulation around food and causes
refrigerator to run longer.
➢ Avoid adding too much warm food to
refrigerator at one time. This
overloads compartments and slows
rate of cooling.
24
cont.
➢ DO NOT use aluminum foil, wax paper,
or paper toweling as shelf liners. This
decreases air flow and causes
refrigerator to run less efficiently.
➢ A freezer that is
efficiently.
➢ Locate refrigerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances. If
this is not possible, isolate exterior by
using a section of cabinet or an
added layer of insulation.
➢ Refer to section in Use and Care
Guide on temperature controls for
recommended control settings.
➢ Clean door gaskets every three
months according to use and care
guide instructions. This will assure
that door seals properly and
refrigerator runs efficiently.
➢ Take time to organize items in
refrigerator to reduce time that door
is open.
➢ Be sure your doors are closing
securely by leveling refrigerator as
instructed in your use and care guide.
➢ Clean condenser coils off as
indicated in the Use and Care Guide
every 3 months. This will increase
energy efficiency and cooling
performance.
How to remove and
replace light bulbs
WARNING
To avoid electrical shock which can
cause severe personal injury or death,
disconnect power to refrigerator
before replacing light bulb. After
replacing light bulb, connect power.
CAUTION
To avoid personal injury or property
damage, observe the following:
➢ Allow light bulb to cool.
➢ Wear gloves when replacing light
bulb.
UPPER FRESH FOOD
SECTION
1. Locate finger
2
full runs most
3
2. Remove light bulbs.
3. Replace with appliance bulbs no
4. Replace light bulb cover by inserting
LOWER FRESH FOOD
SECTION
1. Pinch bottom tabs
2. Remove light bulb.
3. Replace bulb with appliance bulb no
4. Insert top tabs (B) of light cover into
FREEZER SECTION
1. Remove ice bin by
2. Remove light bulb
3. Remove light bulb. Replace with appliance
4. Insert bottom tab (B) of light cover
5. Replace ice bin by sliding in until bin
ICE AND WATER
DISPENSER
1. Locate light bulb inside top edge of
2. Replace light bulb with a
gaps on each
side of clear light
shield. Insert
fingers and press in on each side of
shield. Pull shield down and remove.
greater than 40 watts.
front tabs of light shield into slots
directly in front of light assembly.
(A) on light cover
and pull straight
out.
greater than 40 watts.
liner slots and snap bottom portion
over light assembly.
lifting front of bin
and pulling out.
cover by pinching top tab
(A) and pulling cover out.
bulb no greater than 40 watts.
into liner slots and snap top portion
over light assembly.
locks into place.
dispenser frame. Unscrew to remove.
7-watt, 120 volt bulb.
B
B
A
A
A
B

Publicidad

Tabla de contenido
loading

Tabla de contenido