Technical Data; Control Elements - Würth WGL 2 Traducción Del Manual De Instrucciones De Servicio Original

Non-stationary workplace lamp
Lamp luminous flux
Bulb luminous flux
Operating voltage
Capacity rating
Degree of protection
Protection class
Impact resistance
Housing
Cable
Cable length
Mains plug IP54/CH
Operating temperature
Dimensions (height x width x depth)
Weight approx.
Φ
80,000 lm
Note
The clearance on all sides must be at least 500 mm.

Control elements

(See Fig. I)
1 Carrying handle
2 Front cover panel
3 Pin support
Matching of the lamp to the lighting
situation
You can adapt the WGL 2 to match your individual
lighting situation. The front cover panels are avail-
able for this purpose.
a) With front cover panel
• To illuminate a close-up area.
b) Without front cover panel
• For better illumination at a distance.
8

Technical data

EEK EEK
LED
A++ A++
Art. 0981 180 852
80,000 lm
90,000 lm
100 - 240 V, 50/60 Hz
560 W
IP65
I
IK10
Impact and break-proof
Oilflex 540 P yellow
®
10 m (5 m 3G1.5 mm , 3 m 7G0.75 mm
2
16 A/250 V∼
- 40°C to + 59°C
291 x 650 x 650 mm
18,000 g
CRI
70
Operation
Installation when operating with tripod/
mast system (Fig. II)
Connect the lamp with the pin support to the
■
tripod/mast.
Lock the lamp using the star knob.
■
Operation
(See Fig. III)
1 Potentiometer
2 ON/OFF toggle switch
The WGL 2 lamp can be controlled using the two
toggle switches [2] and the rotary controller on the
control unit.
The control unit is integrated in the power supply
cable.
4 of the 8 Xpect 2 LED modules are connected to
each of the toggle switches.
Clockwise rotation of the potentiometer [1]
increases the illuminance (illumination level), while
anticlockwise rotation reduces it.
)
2
CCT
5000K