Operating Position - Poulan Pro PP258TPC Manual De Instrucciones

OPERATING THE COUPLER
This model is equipped with a coupler which
enables optional attachments to be installed.
The optional attachments are:
Edger . . . . . . . . . . . . . . . . . . . . . . .
Cultivator . . . . . . . . . . . . . . . . . . . .
Blower . . . . . . . . . . . . . . . . . . . . . .
Brushcutter . . . . . . . . . . . . . . . . . .
WARNING:
Always stop unit and dis-
connect spark plug before removing or instal-
ling attachments.
REMOVING PRUNER ATTACHMENT
CAUTION:
When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Attachment
TIGHTEN
2. Press and hold the locking/release but-
ton.
Locking/Release
Button
Attachment
Coupler
3. While securely holding the engine end shaft
and extension shaft, pull the attachment
straight out of the extension shaft coupler.
4. Repeat steps to remove extension shaft
from coupler on engine end shaft.
INSTALLING OPTIONAL ATTACH-
MENTS
CAUTION:
DO NOT use extension shaft
with other optional attachments.
1. Remove the shaft cap from the attach-
ment (if present).
2. Position locking/release button of attach-
ment into guide recess of coupler on en-
gine end shaft.
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
MODEL:
PP1000E
PP2000T
PP3000B
PP4000C
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit. All attachments are designed
to be used in the primary hole unless otherwise
stated in the applicable attachment instruction
manual. Using the wrong hole could lead to seri-
ous injury or damage to the unit.
LOOSEN
Knob
INSTALLING ATTACHMENT
HANGER
An attachment hanger is provided for storage
when attachment is not in use.
To install hanger on attachment:
1. Remove the shaft cap from the attach-
2. Press and hold the locking/release button.
Upper Shaft
3. Push hanger onto the attachment until the
OPERATING INSTRUCTIONS
It is recommended that the engine not be
operated for longer than 1 minute at full
throttle.

OPERATING POSITION

Head
protection
13
Coupler Primary Hole
Locking/
Upper
Release
Shaft
WARNING:
Make sure the locking/
Locking/Release
Button in Primary Hole
ment (if present) and discard.
locking/release button snaps into the hole.
ALWAYS WEAR:
Eye
protection
Long pants
Heavy
shoes
Guide Recess
Attachment
Button