Emptying The Drum; Moving The Wet/Dry Vac; Blowing Feature - RIDGID VAC12000 El Manual Del Propietario

SP6949 VAC12000 ESF-1.qxp_SP6949 5/15/15 12:11 PM Page 9
Operation (continued)

Emptying the Drum

WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before emptying
the drum.
1. To remove the lid to empty contents of
the dust drum simply lift the two drum
latches at the front and rear of the dust
drum and lift the lid assembly up and
off the dust drum and set to the side.
2. Lay the lid assembly upside down on a
clean area while emptying drum or
changing the filter.
3. Dump the drum contents into the
proper waste disposal container.
4. If the contents are liquid, you may
dispose by using the drain provided in
the drum for easy emptying. Simply
unscrew the drain cap and allow the
liquid to drain completely out of the Vac
drum.
WARNING: To reduce the risk of
back injury or falls, do not lift a vac
heavy with liquid or debris. Scoop
or drain enough contents out to
make the vac light enough to lift
comfortably.

Moving the Wet/Dry vac

Should it become necessary to pick the
Vac up to move it, the handles on the
sides of the dust drum are used to lift. To
maneuver the Vac, the pull handle above
the inlet should be used.

Blowing Feature

Your Wet/Dry Vac has a "detachable
blower". It has the capability to be used
as a dedicated blower for yard work,
patio cleanup and workshop applications
to blow sawdust and other debris.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
Drum
WARNING: To reduce the risk of
Latch
injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
CAUTION: To reduce the risk of
hearing damage, wear ear protectors
when using the vac/Blower for
extended time or in a noisy area.
9