LiftMaster RGL-CTL Manual De Instrucciones

INTRODUCTION
The LiftMaster Hi-Intensity Red/Green LED Traffic Light is designed for
use in both indoor and outdoor applications where signaling and traffic
control are required. The Traffic Light puts out hi-intensity red and green
beams that are well suited to areas that require a controlled field of view
for narrow lane signaling and daylight visibility. The Traffic Light is
compatible with Logic 3/4/5.0 operators that can accommodate the
TLS1CARD and RDGRNCARD.
SPECIFICATIONS
FEATURE
Supply Voltage And Current: .............15-30 volts, DC preferred,
Voltage Draw ...............................40 mA max. per LED color
Input Response Time......................Indicator On/Off: 10 ms (max.)
Connections................................. Integral 4-Pin Connector
Operating Temperatures ..................-40° to +50° C (-40° to +122° F)
Environmental Description ...............Fully Encapsulated
ENVIRONMENTAL RATING
Electronics ..................................IEC IP67
Enclosure....................................IEC IP65
ENCLOSURE MATERIAL
Front Cover .................................Polycarbonate
Back Cover ..................................Polycarbonate
NOTE: Outdoor wired models must have cover screws tightened and use
water tight compression fitting to meet environmental ratings.
CARTON INVENTORY
• Traffic Light
• Cable (6.5 feet [2 m])
• Installation Instructions
TRAFFIC LIGHT DIMENSIONS
2"
(50.7 mm)
(43.8 mm)
DESCRIPTION
AC acceptable
(80mA Total Draw)
with Pig Tail
5.03"
(127.8 mm)
.79"
(20.1 mm)
1.73"
HI-INTENSITY RED/GREEN
NEVER use this product as a sensing device for personal protection.
Doing so could lead to SERIOUS INJURY or DEATH.
To avoid SERIOUS personal INJURY or DEATH from electrocution,
disconnect electrical power to operator BEFORE proceeding.
ALL electrical connections MUST be made by a qualified individual.
• Stop ALL traffic through the door BEFORE installing sensor.
• Ensure there is no vehicle or pedestrian traffic through the door until
sensor is installed and tested for compliance with ALL applicable
safety standards (e.g. UL 325).
• Check placement of wiring to ensure moving parts are NOT impeded
by wires.
• Make sure wiring is correct BEFORE applying power to the sensor to
avoid DAMAGE to equipment.
• If the sensor sustains damages (e.g falls), replace it with a new sensor.
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer
or birth defects or other reproductive harm. For more information
go to www.P65Warnings.ca.gov
VIEWING ANGLE
The maximum light intensity of the Traffic Light is at approximately +10 ft. /
-10 ft. of the center line, and falling-off with the increase in distance. This
light is designed for narrow areas where single lane viewing is preferred.
NOTE: Avoid looking directly into the powered LEDs from a close distance.
10 ft.
(3 m)
Center Line
10 ft.
(3 m)
RED
5.83"
(148.1 mm)
(189.9 mm)
GREEN
3.45"
(34.5 mm)
(87.6 mm)
LED TRAFFIC LIGHT
MODEL RGL-CTL
Overhead view
2.34"
(59.3 mm)
7.48"
1.36"
2.34"
(59.3 mm)
6.59"
(167.4 mm)