LiftMaster RGL-CTL Manual De Instrucciones página 2

INSTALLATION
The Traffic Light should be mounted at a height which
maximizes visibility.
1. Secure the Traffic Light to the mounting surface with appropriate
hardware (not provided).
2. Insert the 4-pin connector into the base of the Traffic Light and turn
the hold-down ring clockwise until snug.
NOTE: NPT mounting is recommended when a flat surface is not
available. The Traffic Light housing has 1/2" NPT thread on the top.
Remove top plug to allow NPT mounting. It will accept polished 304
stainless steel or anodized aluminum pipe threads. The bottom thread
is for the 4-pin connector only (not for NPT mounting).
WIRING
Traffic Light Signal Control
Logic 4 and Logic 5.0 Operators
Requires a Timer Light Status Card (TLS1CARD).
Black
Brown
Blue
White (not used)
NOTE: In most cases the Traffic Light can be powered by the operator's transformer. If multiple accessories are powered by the operator, such as 2
sets of Traffic Lights and photoelectric sensors, a transformer upgrade may be required. (See Transformer Upgrades below.) A 460 V operator will not
require a transformer upgrade.
Transformer Upgrades
Factory installed upgrade to 40 Va transformer ........................ 902140VAL
Field replacement 120 Vac/40 Va transformer ..............................21-32780
Field replacement 230 Vac/40 Va transformer ..............................21-32781
WARRANTY
One Year Limited Warranty
LiftMaster warrants to the first consumer purchaser of this product that is free from defect in materials and/or workmanship for a period of 1 year
from the date of purchase.
Timer Light Status
Option Card (TLS1CARD)
6
R3
5
N.O.
4
Comm
R2
3
N.O.
2
Comm
R1
1
5 A, 230 Vac, 30 Vdc
TLS1CARD
Timer Light Status Option Card
White
Control Board
Mounting hardware
(not provided)
Logic 3 Operator
Requires a Red/Green Light Control Module (RDGRNCARD).
T/TS 12
FD/SIS 11
COMMON 10
SIC 9
SIO 8
COMMON 7
Dry Contact Only
40-35757-1
Optional Accessories
4-Pin, 15 ft. (4.6 m) Cable with Pigtail .................................... 4PCWPT-15
External Power Supply .................................................................100MAPS
Provides enough power to operate one RGL-CTL Red/Green Light.
Input: 110VAC
Output Voltage: 24VDC
Top Plug
Hold-Down
4-pin
Connector
To Operator
Power
LEDs
Red/Green Light Control
Module (RDGRNCARD)
D4
D3
WARNING DEVICES MODULE
+5V +24V
R7
D2
K2
TB2
1
R4
R2
D1
3
K1
R8
J1
+
C2
13 10
8
Any color wire
will complete
the circuit.
Brown
Black
Blue
White (not used) Control Board
Output Amperage: 100mA
Cable Leads: 38 ft. (11.6 m)
1/2" NPT thread
Ring
Q2 TB1
3
2
Q1 1
R6
C1 Q3
24 Vdc for
Horn/Strobe
4 1
24V
AC 14
24V
AC 13
TIMER
DEFEAT 12
CMN 11
MAS 10