Route The Cables To The Housing - Axis T92A00 Guia De Instalacion

Page 8
Red/black power cable
+ / GND
+
GND

Route the cables to the housing

5
The following instructions describe the installation of the housing on a bracket. Check the bracket
and select the appropriate description below:
A
Alt. Cables routed through the wall bracket (internal cable channel)
The cable glands are not needed if the cables are routed through the wall bracket.
1. Route the cables through the holes on the underside of the housing.
2. Attach AXIS T92A00 to the wall bracket using the supplied screws.
3. Connect the network cable to the network connector on the camera.
4. If applicable, connect the I/O cables to the connectors as described in the installation guide
supplied with the camera.
5. Proceed to "Connect the power cable to the housing 100-240V AC power cable to AXIS T92A00"
on page 9.
B
Alt. Cables routed through cable glands (external cabling)
1. Attach AXIS T92A00 to the wall bracket using the supplied screws.
1. Remove the ring and blind plug from the
cable gland.
2. Pull the cable(s) through the ring and through
the cable gland. Discard the blindplug (fig.5).
3. Pull the cable(s) through one of the holes on
the underside of the housing.
4. Insert the cable gland and use the supplied
hexagonal screw nuts and rubber washers to secure it.
5. Repeat for each cable gland; unused cable glands are used to seal unused holes (be sure to
retain the blind plugs).
6. Use the crimp tool to attach the RJ45 network connector to the network cable.
7. Connect the network cable to the network connector on the camera.
8. If applicable, connect the I/O cables to the connectors as described in the installation guide
supplied with the camera.
9. Proceed to "Connect the power cable to the housing 100-240V AC power cable to AXIS T92A00"
on page 9.
Wire Connector board
Red DC Power (+)
Black GND
AXIS T92A00 Installation Guide
Camera
Camera DC Power (+)
Camera (GND)
FIG.5
Cable gland
Ring
Cable(s)