Joovy Room 703X Guia De Inicio Rapido página 4

EN FR ES
5 To Fold and Pack the Playard
• Before folding the playard be sure to remove all accessories from the playard including the bassinet, changing table, parent organizer, or
any other attachments.
• To fold the playard, release the Velcro® straps on the corners of the mattress from the underside of the playard floor. See Figure 5.1.
• Lift the mattress from the playard and set it aside. If necessary, remove the mattress sheet.
• Push the release button near the center of the playard floor. See Figure 5.2.
• Pull upward on the red handle near the center of the playard floor. Be sure that the center is pulled up all the way. See Figure 5.3.
• With the center of the floor pulled up, locate the button at the center of one of the top rails.
NOTE: The button is sewn inside the fabric near the center of each top rail.
• Pull upward on the top rail and squeeze the button. Then push down until the locking mechanism is released on BOTH sides of the top
rail. See Figure 5.4.
NOTE: If the rail tubes do not unlock, do not force them. Lift the center of the floor higher and try again.
• Once you have successfully released BOTH tubes and folded that top rail, repeat this procedure on the other top rails until all four top rails
have been folded.
• Gather the playard together until it is compact and completely folded. See Figure 5.5.
NOTE: DO NOT force the playard. If the unit will not fold, look for a partially latched top rail and squeeze the button in to release the rail.
• Lay the mattress on the floor with the soft side facing up. Lay the folded playard frame, bassinet, and parent organizer on the mattress,
and fold the mattress around the frame with the short section tucked in. See Figures 5.6 and 5.7.
• Locate the Velcro® straps on the end of the mattress, thread them through the plastic rings on the other side of the mattress and attach
them. See Figure 5.8. Then stand the playard upright.
NOTE: There are three straps; one near the top, one near the center and one near the bottom.
• Open the zipper on the large section of the travel bag and slide the bag over the folded playard with the handle on the outside of the
playard mattress facing the opening of the bag. See Figure 5.9. Once the playard is completely inside the travel bag, close the zipper.
When inserted properly, the handle should be accessible through the opening in the bag.
NOTE: The changing table and its components can be stored in the small section of the travel bag.
Please read these instructions carefully before use and keep them for future reference.
• Failure to follow these warnings and the instructions could result in serious injury or death.
• FALL HAZARD: To help prevent falls, do not use this product when the infant begins to push up on hands and
knees or weighs over 15 lbs. (6.8 kg), whichever comes first.
• SUFFOCATION HAZARD: Infants have suffocated:
• In gaps between extra padding and side of bassinet/cradle.
• On soft bedding.
• Use ONLY the mattress pad provided by Joovy.
• NEVER add a pillow, comforter, or another mattress for padding.
• To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their back to sleep, unless
otherwise advised by your physician.
• If a sheet is used with the pad, use only the one provided by Joovy which is specifically designed to fit the
dimension of this bassinet mattress.
• Strings can cause strangulation! DO NOT place items with a string around a child's neck, such as hood strings or
pacifier cord. DO NOT suspend strings over bassinet or attach strings to toys.
• Use bassinet with only one child at a time.
• NEVER place a child under the bassinet.
• The bassinet must be fully assembled per Joovy's instructions before using. Do not modify the bassinet or add any
attachments not specifically recommended by Joovy.
• DO NOT store the bassinet in the playard while in use.
• The bassinet is designed for use ONLY on this Joovy playard. DO NOT use on any other product or surfaces.
6 Installing the Bassinet
• With the playard erected and any accessories removed, remove the mattress from the bottom of the playard to use inside your bassinet.
Set the mattress aside.
• Unfold the bassinet. Locate the support tubes on the underside of the bassinet and connect each tube to its corresponding partner. See
Figure 6.1.
• Position the bassinet so the plastic rail attachments are at the top.
• Secure all plastic rail attachments onto the top rails of the playard so they are directly adjacent to the plastic corners. The long plastic
attachment correspond with the long rails and the short plastic attachments correspond with the shorter curved rails. See Figure 6.2.
• Place the mattress into the bassinet support with the soft side facing up.
FOLLOWING INSTRUCTIONS ARE FOR THE BASSINET
WARNING
!