General Safety Instructions For Compressed Air Tools; Hazards Caused By FLying Parts - Parkside PDEXS 150 C2 Manual De Instrucciones

Noise emission values:
Noise measurement determined in accordance
with ISO 15744.
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty:
Wear ear protection!
Vibration emission value:
Vibration emission value determined in accordance
with ISO 28927-3 and EN 12096:
a = 8.27 m/s 2
h
Uncertainty K = 0.82 m/s
WARNING!
► The noise emission levels specified in these
instructions have been measured in ac-
cordance with the standardised measuring
procedure specified in ISO 15744 and can
be used to make equipment comparisons.
The noise emission values vary in accordance
with the use of the compressed air tool and
may be higher than the values specified in
these instructions in some cases. It is easy to
underestimate the noise emission load if the
compressed air tool is used regularly in a
certain manner.
NOTE
► For an accurate estimate of the noise emis-
sion load during a certain working period,
the times during which the appliance is
switched off or is running but not actually
being used must also be taken into considera-
tion. This can significantly reduce the noise
emission load over the total working period.
PDEXS 150 C2
L = 90.4 dB (A)
pA
K = 3 dB
pA
L = 101.4 dB (A)
WA
K = 3 dB
WA
2
WARNING!
General safety
instructions for
compressed air tools
WARNING!
► For multiple hazards: Please ensure that you
have read and understood the safety instruc-
tions before adjusting, operating, repairing,
maintaining or replacing accessories on
the sander or working in the vicinity of the
machine. Failure to do this can result in seri-
ous bodily injury.
■ The sanding machine for sanding sheets or the
polisher should only be adjusted, set or used by
adequately qualified and trained operators.
■ This sanding machine for sanding sheets or the
polisher may not be modified. Modifications can
reduce the effectiveness of the safety measures
and increase the risks for the operator.
■ The safety instructions should not be lost – give
them to the operator.
■ Never use damaged sanding machines for
sanding sheets or polishers.
■ The appliance must be inspected regularly to
ensure that it is labelled with the required rated
values and markings given in this manual. The
user must contact the manufacturer to obtain
replacement labels if necessary.
Hazards caused by flying parts
■ If a workpiece or accessory or even part of the
machine tool itself breaks, parts can be flung
out at high speeds.
■ When operating the sanding machine for sand-
ing sheets or the polisher or when exchanging
accessories on the device, always wear eye
protection. The degree of necessary protection
must be evaluated separately for each individual
task.
■ Wear a safety helmet if working above head
height. In this case, the risks for others should
also be assessed.
■ You must ensure that the workpiece has been
securely fixed.
GB │ IE │
17 ■