Installation - Panasonic AW-PH400 Manual De Operación

Roll Unit AW-RL400

Installation

1 Attach the pan/tilt head's rotary arm to the roll unit using the accessory three screws (M4!8 mm, with flat washers).
2 Attach the rotary arm to the pan/tilt head using the rotary arm mounting screws (M5!20 mm, with flat washers, pan/tilt head
accessory).
3 Loosen the two screws of camera mounting plate which is already installed to the roll unit.
Then remove the camera mounting plate.
4 Attach the camera mounting plate (it was removed in step 3) to the camera unit using two camera mounting screws (camera
accessory).
Roll unit mounting screws
Rotary arm
Camera mounting plate
Screws
Rotary arm mounting screws
Camera mounting plate
Camera mounting screws
43 (E)
Roll unit
Camera mounting plate