Publicidad
Idiomas disponibles
Idiomas disponibles
Drying Procedures
Fol}ow fabric care label instructions
Place smali items in a mesh bag
Fill dryer drum 1/3 lo It2 full,
An
3.
4_
.
6.
. Follow the guidelines below for preparing the load ior drying
• Read the Operating
Instructions
card for operating your specific model
• Always read and follow fabric care labels and laundry product
labels.
To reduce the risk of fire, electrical shock, or injury to persons,
read Important
Safety Instructions,
pages 3-4, before operating this dryer.
Prepare
items for drying.
•
Dry items of similar fabric, weight and construction in the same load.
•
Separate dark items from fight-colored items° Separate items that shed
lint from those that attract lint If an item sheds lint, turn it inside out.
•
Be sure buckles, buttons and trim are heatproof and won't damage the
drum finish_ Close zippers, fasten hooks and Velcro_like
fa_teners_
Tie strings and sashes to prevent snagging and tangling_
•
If possible, turn pockets inside out lor even drying.
•
Check for stains which may not have been removed in washing
Dryer
heat may permanently set some stains_ Repeat stain removal
process
before drying..
•
Place small items in a mesh bag to prevent tangling and for easy
removal..
Check
that lint screen
is clean and in place.
Load the dryer.
-
The average load wilt fill the drum 1/3 _o 1/2 full. Items need room to
tumble freety for even drying and less wrinkling Do not overload
dryer,
•
When drying large items, dry only 2 or 3 at a lime, Fill out the lbad with
small and medium sized items
For delicate or very small loads, add 2 lint-free towels for better drying,
less wrinkling, and to prevent grease stains caused by fabric softener
sheets.
Do net overdry items Overdrying can cause wrinkling, shrinkage,
harshness, and a build-up of static electricity, which can produce
more
linL
If desired, add a dryer fabric softener sheet
Close the dryer door and set dryer controls
(some
models).
See Operating
Instructions
card for your specific model controls
Turn cycle selector
clockwise
to the desired
setting.
Start the dryer.
•
Turn the START knob clockwise _oON Hold for 1-2 seconds
and
release
•
To add or remove items when tile dryer is running, open the door. The
dryer will always stop when tile door is opened, Allow the drum to
come to a comptete stop before reaching inside.
•
To rested dryer, close the door then turn the START knob clockwise to
ON Hold for 1-2 seconds and release.
7. When the cycle ends, remove
items immediately
and
hang or foid,
If load is removed before the cycle ends, turn cycle selector
to OFF
rrl
C)
r-
O3
3::
Publicidad
