Jerdon PRO Versa JMP16W Manual De Instrucciones página 5

HOW TO USE THE STYLING DRYER: Your hair dryer may feature a choice of two
speeds and two heat settings. Use High heat/speed (II/2) for most styling setting
procedures and hair types. Select Low heat/speed (I/1) for 'finishing' a hairstyle or
for drying and styling permed, color-treated or fragile hair.
HOW TO USE COOL SHOT ( ) (if included): By pressing the Cool button while
drying or styling, the air temperature is reduced to minimum heat. Ideally this is the
last phase of blow drying your hair. If the knob is released, the appliance will
operate again at the preset temperature.
HOW TO USE THE CONCENTRATOR (if included): If you wish to direct or
concentrate the air stream to a specific area, you can snap the included nozzle to the
air outlet opening of the dryer.
HOW TO USE THE DUAL VOLTAGE DRYER (if included): For use in the U.S.A.,
the voltage selector should be in the 125-volt position. On 125 volts AC, you can
use either Low heat/speed or High heat/speed. For use in several countries
overseas, the voltage selector may need to be placed in the 250-volt position.
Confirm the voltage available at each overseas location before using the appliance.
For connection to a 250-volt supply, use an attachment plug adapter of the proper
configuration for the power supply receptacle.
HOW TO CHANGE VOLTAGE (if included): Before changing the voltage selector to
the 250-volt setting, be sure the power switch is in the OFF position. When using the
250-volt setting, the dryer will work only in the Low position, but it will be operating at
High heat/speed. Do not try to force the switch into the High setting. Use an
appropriate instrument to move the voltage selector to the 125 or 250-volt setting.
C Y H D
LEANING OUR AIR RYER
This appliance is permanently lubricated and will not require additional lubrication for
the life of the unit. It contains no user serviceable parts.
While Using: Untwist cord from time to time to avoid tangling.
To Clean: Unplug unit and allow to cool. Use a soft, slightly damp cloth to wipe the
surfaces. Do not allow water or any other liquid to get into the unit. Intake grille
must be cleared of any build-up of lint or hair with a small dry brush.
To Store: Unplug appliance and allow to cool. Store in dry place. NOTE: Never
store while it is hot or still plugged in, wrap the cord tightly around the appliance,
hang the unit by the cord (use hanging ring provided) or put any stress on the cord
where it enters the unit, as it could cause the cord to fray and break.
5