Tabla De Contenido; Recognize Safety Symbols, Words And Labels; Important Safety Instructions; Installation Checklist - Kenmore 41791122310 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
Please read all instructions before using this dryer.
Recognize safety symbols, words and
labels
Safety items throughout this manual are labeled with
a WARNING or CAUTION based on the risk type as
described below:
Defi nitions
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible injury
or death.
DANGER
DANGER indicates an imminently hazardous situation
which, if not avoided, will result in death or serious
injury.
WARNING
WARNING indicates a potentially hazardous situation
which, if not avoided, could result in death or serious
injury.
CAUTION
CAUTION indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate
injury.
IMPORTANT
IMPORTANT indicates installation, operation or
maintenance information which is important but not
hazard-related.
Table of Contents
Important Safety Instructions ............................................ 2-3
Installation Requirements ................................................. 4-10
Dryer Dimensions ................................................................... 11
Installation Instructions ................................................... 12-20
Reversing Door ................................................................ 21-23
Accessories ........................................................................... 24
Español ...................................................................................25
Français ................................................................................. 48

Important Safety Instructions

Installation Checklist

Exhaust Venting
Free-fl owing, clear of lint buildup
4 inch (102 mm) rigid or semi-rigid ducting of
minimal length and turns
NO foil or plastic venting material
Approved vent hood exhausted to outdoors
Leveling
Dryer is level, side-to-side and front-to-back
Cabinet is setting solid on all corners
Water Supply (steam models only)
Rubber washer (shipped in drum) is installed in
NEW inlet hose (shipped in drum)
Inlet hose connected to "Y" connector on COLD
supply
Water supply turned on
No leaks present at water supply connections
or appliance inlet connection -
recheck in 24 hours
Gas Supply (Gas Dryer)
Manual shutoff valve present in supply
All connections sealed with approved sealer
and wrench tight
Conversion kit for LP system
Gas supply turned on
No leaks present at all connections -
check with soapy water, NEVER check with fl ame
240v Electric Supply (Electric Dryer)
Approved NEMA 10-30R or 14-30R service cord
with all screws tight on terminal block
Approved strain relief installed
Terminal access cover installed before initial
operation
Door Reversal
Follow detailed instructions in this guide
Test hinge and latch for function
Electrical Power
House power turned on
Dryer plugged in
Final Checks
Installation Instructions and Use and Care
Guide have been read thoroughly
Door latches and drum tumbles when cycle
starts
3

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido