Secondary Functions; Set Display Dampening; Keel Offset; Simulation Mode - Navman D100 Manual De Usuario

Secondary Functions

Set Display Dampening

Rough water conditions, schools of fish and
thermal layers cause erratic depth readings.
Display dampening controls the rate that the
displayed depth can change and will help remove
these variations. There are three levels of
dampening with d1 having the least effect and
d3 having the greatest effect. When operating in
shallow water or at high speed it is best to use a
low level of dampening.
Press and hold the
seconds.
Use the and
value.
When correct value is displayed, press the
key to exit.
NAVMAN D100 User Manual
and keys for 3
3 SECS
keys to set the required

Keel Offset

The NAVMAN D100 will normally display the
depth of water below the face of the transducer.
You may introduce a keel offset to reduce the
displayed depth or a waterline offset to increase
the displayed depth.
While in the Display Dampening mode, press
and keys.
the
Use the and
value.
When correct value is displayed, press the
key to exit.

Simulation Mode

The NAVMAN D100 has a simulation mode.
To enter this mode hold down the
then switch on the power. The instrument will
remain in this mode even when power is
switched off.
Repeat this procedure to exit simulation mode.
Note:
Settings that are made while in
simulation mode will remain in effect
after returning to normal mode.
keys to set the required
key and
9