Solar BA427 Manual Del Usuario página 6

Using the arrow keys, scroll down to CONFIGURATION and press "ENTER" to go
to the CONFIGURATION Screen. To set the date and time, scroll to SET DATE and
press "ENTER". The tester will display the date and time currently set for the tester.
The indicator arrow should be on the date line. Press "ENTER". ADJUST: YEAR will
appear on the display. Using the Arrow Keys, toggle to the correct year and press
"ENTER". Repeat this process as the tester advances through the MONTH, DAY,
HOUR, MINUTE and SECOND settings. Upon pressing "ENTER" after making the
SECOND setting adjustment, you will return to the Function Screen.
Using the arrow keys, scroll down to CONFIGURATION and press "ENTER" to
go to the CONFIGURATION Screen. To adjust the display brightness, scroll to
BRIGHTNESS and press "ENTER". Using the Arrow Keys, adjust to your preferred
level of brightness and press "ENTER".
To learn more about the counter operation, see Counter Function section of this
manual.
Using the arrow keys, scroll down to CONFIGURATION and press "Enter" to go
to the CONFIGURATION screen. To customize your printout information, scroll to
CUSTOMIZE and press "Enter". Follow the prompts to enter your information to be
printed on test strips.
Battery Tester Operation
Note: Each time you connect the tester to a battery, the tester will run a quick
cable verification to ensure a proper connection through the output cables to
sensors in the clamp jaws. If the connection checks out OK, the display will
momentarily flash "Output Cable Check Complete" and proceed to the Home
Screen. If the connection is poor, the display will show "Cable Error – Replace
Cables." In this case, check cable connections for visible signs of damage, as
you may need to replace the cable ends. Call Technical Service at 800.328.2921
with any questions.
Battery Testing
1. Before you test a battery in a vehicle, turn off the ignition, all accessories and
loads. Close all the vehicle doors and the trunk lid.
2. Make sure the battery terminals are clean. See Preparing Battery to Be Tested.