Velleman VMM501 Manual De Instrucciones página 23

5.10 Motor
1x micro:bit board
1x micro:bit breadboard adapter
1x breadboard
1x diode
1x 100 Ω resistor (brown/black/brown/gold)
1x self-locking or bi-stable switch
1x N-channel MOSFET
1x mini motor
1x battery holder with 2x AA 1.5 V battery
We are going to use a switch to control the start and stop of a motor.
Place the necessary components on the breadboard as shown.
Have a look at the code below.
1. Drag and drop the code blocks to form the code as shown.
2. The
3. Set the value of P0 to 0.
4. Set the
V. 01 – 17/01/2019
VMM501
on start block runs only once to start the programme.
pull pin block to P1 and up.
23 ©Velleman nv