Filters; Hepa Media Final Filter; Important; Replacement Filter - Hoover MPWR 40V Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Filters

WARNING:
OR SERVICING. DO NOT OPERATE VACUUM WITHOUT BOTH INLET FILTER AND FINAL FILTERS IN PLACE.

HEPA MEDIA FINAL FILTER

The final filters assist in the filtration process to return cleaner air to the room. There are 2 HEPA
Filters, one on each side of the backpack.
1
Remove filter door
by pulling rear tab
forward and rotating
out.

IMPORTANT:

EDGE SO AIR CIRCULATES ON BOTH SIDES OF FILTER. THIS MAY TAKE UP TO 24 HOURS.

REPLACEMENT FILTER

Inspect HEPA Media Final Filter every month, rinsing when necessary. Check for
wear of media and replace if pleats are damaged. Change filter regularly to maintain
maximum performance.
HEPA Media Final Filter 2 Pack Part No. AH40006
16
TO REDUCE THE RISK OF PERSONAL INJURY – REMOVE BATTERY BEFORE CLEANING
2
Pull filter out by the
frame. Hand rinse in
cold water under low
pressure. Rinse only
surface facing inside
of machine. Let dry for
24 hours and reposition
into the filter housing.
ALLOW FILTER TO DRY COMPLETELY BEFORE REPLACING. DRY FILTER ON
3
To replace filter door,
align the two forward
facing tabs and rotate
into place. Press rear
tab until door snaps
into place.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ch93619

Tabla de contenido