Hardware Installation - Signamax Connectivity Systems 065-1755 Manual De Instrucciones

2. Hardware Installation

1. Power off your network devices.
2. Locate an optimum location for the AP. The best place for the AP is
usually at the center of your wireless network, with line of sight to all of
your wireless devices.
3. Adjust the antennas. Normally, the higher location of your AP will get
better the performance.
4. Using a standard Ethernet network cable, connect the AP's Ethernet port
to your local network.
5. Connect the AC power adapter to the AP's Power port. Then connect the
other end to an electrical outlet. Only use the power adapter supplied with
the AP. Use of a different adapter may cause product damage.
6. The Hardware installation is completed. Please refer to the following
content or user guide for AP configuration.
Verify Hardware LED status
Verify the following LED lights are on:
Power: The Power LED lights up and will keep while the AP is powered
on.
11a: The 11a LED flashes when there is a successful Wireless-A
connection.
11g: The 11g LED flashes when there is a successful Wireless-G
connection.
4