Controls & Operation; Important - Troy-Bilt CS 4265 Serie Manual Del Operador

Controls and Operation
Handle
Recoil
Starter
Controls
Chipper Chute
Branches up to two inches (model series CS 4265) or
three inches (model series CS 4325) in diameter may
be fed into the chipper chute for chipping.
Hopper
Leaves, twigs, and branches up to 1/2-inch in
diameter may be placed into the hopper for
shredding.

IMPORTANT:

Never place branches with a diameter
greater than 1/2-inch in the hopper. Doing so can
result in serious damage to your unit's shredder
blade, flails or impeller.
Handle
Use the handle when manually transporting the
chipper shredder.
6
Hopper
Chipper
Chute
Lock Rod
Recoil Starter
The recoil starter is located on the engine. Pull the
recoil starter to start engine.
Engine Controls
See the separate Engine Operator's Manual packed
with your unit for the location and function of the
engine controls.
Spring Latch (Model Series CS 4325 Only)
The spring latch is located on the top of the hopper.
It is used to release or lock the chipper chute in a
raised position for storage or for transporting.
Spring
Latch
Figure 4-1
WARNING:
Never operate the chipper
shredder with the chipper chute in the
raised position. Use the spring latch to
lower the chipper chute into the
operating position before starting the
engine.
Chute
Deflector
Model Series CS 4325 Shown
Lock Rod (Model Series CS 4325 Only)
The lock rod is located on the chipper chute support.
It is used to release or lock the chipper chute in a
lowered position for operation.
Chute Deflector
Debris is discharged from the machine's reduction
chamber through the chute deflector.
4