Tabla de contenido

Publicidad

Press
key.
Enter required time interval in hh:mm (ie, in order to take a reading
every 1 minute, key in 0001) and press
return to display and
will continue logging until a maximum of 250 readings are taken or
data is down-loaded.
OUTPUT OF DATA
This feature will only function if either the
displayed.
To view data press
reading will be displayed. Press
readings and any other key to return to normal mode.
To output data to a PC press
To output data to an Epson compatible printer press
by key. Printer settings must be as follows: 9600 Baud, 8 data bits,
4
No Parity, One stop bit, No flow control. It is also possible to print to
Hyper Terminal in your PC in this way.
receive information.
The selected transmit option will be displayed during transmission.
After transmission, the unit will return to normal operation and any
auto logging will stop.
To erase stored data press
There will be a delay before the unit will accept the
symbol
will be displayed. This is to help stop accidental erasure.
After erasure, neither
will return to normal mode.
delete data, you must turn instrument off and on, then the stored
data will not be lost.
AVERAGING
Press
X
key (when in
with average reading, will appear on display. Press
to return to
X

LEAK TESTING

This function enables testing for leaks in pressure systems. The
instrument has a function to automate leak testing in a variety of
applications.
Automatic leak test results are logged, not stored and cannot be
output directly via HHP-2000DL into your MLWIN software. To send
leak test results to your PC please use your PC's Hyper Terminal and
output as to an Epson Printer. When entering pressure values (P1,
P2, P3) you must enter numbers to exactly the same number of
decimal places as full pressure range of the instrument being used.
The number of decimal places required can be seen in the table of
pressure ranges on the back page.
SETTING UP
Press
key (when not in
X
symbols will appear on the display. Enter pre-stress pressure level
(if pre-stress pressure function is not required, press
display will show
press
key and the
Key in test time in minutes and seconds (MM.SS), press
the
NE
and
P3
change in pressure and press
to run test and
NE
symbol and
symbol will remain on display.
key, then and
or
If after pressing key you do not wish to
MAX/MIN
MAX/MIN
mode.
MAX/MIN
NE
and
P2
NE
and
symbols will now be displayed. Key in permissable
P1
will appear on display.
0000
will appear on the display.
key. Current reading will
1
keys. The first stored
key to view successively stored
key, then key.
2
Ensure PC/Printer is ready to
key, then and
3
symbols will be displayed. The unit
3
mode) and
mode) and
symbols. Key in start pressure and
symbols will now be displayed.
key. The instrument is now ready
Instrument
or
symbols are
key, followed
keys.
key and
symbol, together
NE
and
P1
key) and the
key and

Publicidad

Tabla de contenido
loading

Tabla de contenido