Dmx Linking; Dmx Connection; Signal Wiring - Iluminarc Ilumipod 36g2 IP Guía De Referencia Rápida

Ilumipod 36g2 IP QRG

DMX Linking

DMX Connection

Signal Wiring

DMX Junction Box
Wiring
The Ilumipod 36g2 IP will work with a DMX controller using a regular
DMX serial connection.
www.iluminarc.com.
This product provides a DMX 512 connection by using bare-ended
IP67-rated signal cable. This cable comes connected to the product. See the
User Manual to connect and configure for DMX operation.
To provide the signal, you have two options:
·
Connect the bare-ended IP67-rated signal cable from the product to two
IP67-rated signal connectors (DMX In and DMX Out).
·
Use an IP67-rated junction box. If so, make sure to use IP67-rated
conduit.
The signal cable must match or exceed the electrical characteristics of
the Belden 9841 cable for EIA RS-485 applications. You can also use
CAT 5, CAT 5e, or CAT 6.
Signal In
Junction Box
A DMX
1: Common (Shield)
2: Data – In (Black)
3: Data + In (White)
4: Data – Out (Green)
5: Data + Out (Red)
Conduit
4
Primer is available
Junction Box
EN
from
Signal Out