Ilumicode Connections - Iluminarc Ilumipod 36g2 IP Guía De Referencia Rápida

Ilumipod 36g2 IP QRG
Ilumicon and
DMX
Controllers
Ilumicode
Control Panel
Description
Ilumicode
Connections
Ilumicode
Connection
Diagram
To control/operate the Ilumipod 36g2 IP, use either an Ilumicon or a DMX
controller. Use the standard DMX connection as shown in the DMX
Junction Box Wiring section to connect this product to any standard DMX
controller.
Button
<MENU> Exits from the current menu or function
Enables the currently displayed menu or sets the currently
<ENTER>
selected value into the selected function
Navigates upwards through the menu list and increases the
<UP>
numeric value when in a function
Navigates downwards through the menu list and decreases
<DOWN>
the numeric value when in a function
This diagram shows how to control multiple products at the same time. All
connected products will be assigned to the same DMX address.
To assign individual DMX addresses to each product, connect the
Ilumicode to each product individually. Be sure to disconnect the DMX
output of the product being configured if other products are connected to it.
Power
Signal
Ilumicode
Addresser
ILUMINARC suggests connecting no more than 20 products in this mode,
keeping the total distance to less than 60 m (197 ft). If not, you may need to
use an optically isolated signal amplifier.
1: Gnd
1: Gnd
2: Data – (Green Clip)
2: Data –
3: Data + (Red Clip)
3: Data +
Signal Connector
DMX Output
5
Function
To
Other
Products
(Black Clip)
EN