Explanation Of Symbols; Charging The Battery - Scotts LSS10172S El Manual Del Propietario

FCC Warnings:
Please note that changes or modifications to this
product not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
Precautions that involve your safety.
CAUTION! Read the instruction manual and follow the warning and safety instructions!
CAUTION! Always wear eye protection.
Do not use in rain or electrical storms.
WARNING! Wear protective gloves!
WARNING! Keep bystanders away.
CAUTION! Wear ear protection
WARNING! Wear safety footwear!
The battery must be fully charged before using

for the first time. The charging time is 3 to 5
hours. (See page 5 for instructions.)
The battery charger supplied matches the

lithium battery installed in the tool. DO NOT
use any other charger to recharge the tool.
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.
GENERAL SAFETY

EXPLANATION OF SYMBOLS

!

CHARGING THE BATTERY

3
Model LSS10172S
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
To protect the lithium battery against deep

discharging, when the battery is flat, the tool
will automatically switch off via a protective
circuit.
If the On/Off switch is used continually at this point,
the lithium battery can be damaged. Do not try to
continue to use the tool before recharging the
battery.