KENMORE ELITE 721.8758 Manual De Usuario página 14

STEP 5: Install the Mounting Plate
Connect the Oven to at Least One Wall Stud.
1. Center the rear wall template in the space by lining up the
plumb line on wall with centerline on template.Then securely
tape or tack the rear wall template in place.Make sure the
minimum width is 30 inches and that the top of the rear
wall template is located a minimum of 30 inches above
the cooking surface. See Figure 26.
NOTE: If the cabinets are not plumb, adjust the rear wall
template to the cabinets. If the front edge of the
cabinet is lower than the back edge, adjust the
template to be level with the cabinet front.
2. Drill holes at points A, B. Drill the third hole inside area C,
through one of the bottom holes to match the location of
a stud. If there is a stud, drill a 3/16 hole for lag screws.
If there is no stud, drill a 5/8 hole for toggle bolts.
These holes must be used for mounting. If the holes are
not used, the installation will not be secure. Installer must
use these holes for proper installation. See Figure 30.
Use toggle bolts through these holes, unless one of them
lines up with a stud. Use a wood screw for studs.
Make sure to use at least 1 lag screw in a stud,
and 2 toggle bolts in the drywall or the plaster.
NOTE: Cut out the shaded area marked F on the REAR
WALL TEMPLATE for wall-venting.
3. Remove the template from the rear wall.
4. Attach the plate to the wall. To use spring toggle head bolts:
Remove the toggle wings from the bolts. Insert the bolts into
the mounting plate and replace the spring toggle head to 3/4
past the bolt ends. Insert the spring toggle head into the
holes in the wall to mount the plate. You may pull forward on
the plate to help in tightening the toggle bolts. Tighten all
bolts. See Figure 31.
Minimum 66
From the Floor
Mounting
Plate
– 14 –
3/16 Hole on Studs
5/8 Hole on Drywall Only
For Wall -
Venting Only
Draw Lines
on Studs
Center Line
Mounting Plate
Center Line
A
C
Support Tab
Figure 30
Space More Than Wall Thickness
Toggle Wings1
Toggle Bolt
Wall
Figure 31
Draw
B
Support Tab
Bolt
End