KENMORE ELITE 721.8758 Manual De Usuario página 9

STEP 3: Prepare the Venting Blower
Your microwave oven is shipped with the blower assembled for
want wall-venting or room-venting installation.
ELECTRIC SHOCK HAZARD! UNPLUG UNIT BEFORE WORKING ON IT.
• DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could result in
electric shock.
1. Remove any shipping materials and parts from inside the
microwave oven. Set them aside for later use.
2. Cover the counter top or cooktop with a thick, protective
covering to protect it from damage and dirt. See Figure 11.
NOTE: If you have a free-standing range, disconnect
it, move it onto a piece of cardboard or hardboard and
pull it away from the wall, so that you can get closer to
the upper cabinet and back wall for easier measuring
and drilling.
3. Locate the exhaust adaptor, grease filters and hardware packet.
4. At this point, remove any adhesive tape (if there is any), on the
exhaust adaptor, the grease filters and the power supply cord.
• Do not remove the packing tape on the slide-out vent.
ROOF-VENTING INSTALLATION:
This oven is shipped assembled for roof-venting.
1. Insert the tabs on each side of the damper into the holes
at the inside rear of the adapter.
Attach the exhaust adapter to the blower plate with the two
tapping screws provided. See Figure 12.
Make sure that the damper swings freely.
FIRE HAZARD! CORRECTLY INSTALL THE VENT FAN BEFORE USE .
• When changing the vent fan position for a rear wall vent or room vent:
1. Properly align the ventilation fan openings and blower plate knockouts.
2. Ventilation fan openings should be completely exposed to the outside.
3. After installation, check the air ventilation path. Refer to page 7 Figures 6-8 for proper vent selection.
• Improper installation can cause problems such as:
1. Inability to assemble blower plate or ventilation motor correctly.
2. Abnormal noise during product operation.
3. Weak ventilation.
4. Product overheating - possibility of product breakdown or fire.
roof-venting. You need to adjust the blower if you
w
W A R N I N G
w
W A R N I N G
– 9 –
NOTE: Set the product down on a flat surface only.
Figure 11
Figure 12
A thick, protective
covering
Damper
Exhaust
Adapter
Blower Plate
Back of
Oven