Technical Data; Special Safety Instructions - Schou Max 61011 Manual De Instrucciones

JIG SAW
Introduction
To get the most out of your new jig saw,
please read through these instructions
before use.
Please also save the instructions in case you
need to refer to them at a later date.

Technical data

Voltage/frequency:
Power rating:
Speed:
Saw depth:
Wood
Metal
Angling:
Can use both T-shank and U-shank blades.
Sound pressure, L : 84,7 dB(A), Kpa: 3 dB(A)
pA
Sound level, L :
wA
Vibration: ah, cw = 6,82 m/s
Vibration: ah, cm = 4,68 m/s
The table below shows how long you
may be exposed to vibration every day, if
the vibration load of 2.5 m/s
exceeded:
Vibration Max. exposure
2.5 m/s 8 hours
2
3.5 m/s 4 hours
2
5 m/s 2 hours
2
7 m/s 1 hour
2
10 m/s 30 minutes
2
24
230 V~ 50 Hz
400 W
0-3300 impacts/min
55 mm
6 mm
0-45°, right/left
95,7 dB(A), Kpa: 3 dB(A)
, K: 1,5 m/s
2
, K: 1,5 m/s
2
is not to be
2

Special safety instructions

Always unplug the jig saw before changing
the blades or making any other adjustments!
Do not use for cutting pipes or cables.
Do not use cracked, blunt or damaged
blades.
Do not start the saw if no blade is � tted.
Check there are no obstructions in the
surface under the item to be cut.
Do not attempt to cut items thicker than
the maximum cutting depth of the blade, or
where there is insuffi cient clearance for the
blade under the item.
The saw's metal parts may become
conductive if the saw comes into contact
with a live wire. You should therefore only
hold the jig saw by its insulated handle.
Check that the motor's vent holes are not
blocked.
Always wear a face mask if excessive
2
amounts of dust are generated or if sawing
2
hazardous materials.
Never remove dust, obstructions or the
like from the work area while the blade is
operating.