DAB FEKABOX 110 Instrucciones Para La Instalación Y El Mantenimiento página 25

4. INSTRUCTIONS FOR USE
FEKABOX is a preassembled system, ready for installation, requiring no adjustment; it is ideal for the collection
and disposal of sewage and domestic waste water from cellars, situated below the level of the sewer network. In
compliance with the accident-prevention regulations in force, the FEKABOX cannot be used for conveying
inflammable or explosive liquids, such as petrol, diesel fuel, fuel oil, solvents, etc.
5. INSTALLATION
Do not lift, carry or operate the pumps holding them hanging by their power cable.
5.1
5.2 An example of installation is shown on page 20.
5.3 The tank may be laid on the floor, under the ground or housed in a masonry pit.
In any case the surface on which it is laid must be perfectly horizontal and it must be ensured
that the whole bottom of the tank is in contact with the surface.
For Fekabox 200 l and Fekabox 280 l the cover of the tank is trafficable (max. weight 100 Kg).
Attention! For Fekabox 110 l the cover of the tank IS NOT TRAFFICABLE.
Ensure that the difference in level between the pump and the sewage network is
compatible with the pump performance.
5.4 Pump assembly procedure
5.4.1 110 l tanks: For the parts references, see the diagram on page 17
5.4.2 200 l tanks: For the parts references, see the diagram on page 18
1. Remove the cover of the tank, slackening the retaining screw on the metal strap and removing
the straps around the cover.
2. For FEKA VS-VX check that the length of the pump float is 250 mm (see fig. B page 18).
3. Fix the pump to the base plate (253) with the special screws and spacers for Feka VX, turning
the delivery port to face the notch (see fig. A on page 18).
4. Position the whole assembly on the bottom of the tank, on the central convex part.
5. Connect the pump to the delivery hose. For FEKA 600 use the coupling (118b-118c).
6. Check that the clamps of the delivery hose are correctly fixed.
ENGLISH
FEKABOX 200
FEKABOX 280
22